Common LG washer codes
| Code | What it means | Usually caused by |
|---|---|---|
| OE | Not draining | Clogged pump filter, kinked hose, failed drain pump |
| UE / uE | Unbalanced load | Bunched load, unlevel washer, worn shocks |
| LE | Motor locked or overloaded | Overload, rotor position sensor, motor fault |
| dE / dE1 / dE2 | Door lock issue | Door not latched, failed door lock |
| IE | No water fill | Closed valve, clogged inlet screens, inlet valve |
| tE | Heating or temperature | Heater or thermistor fault |
Try this before you book
- OE: Clean the drain pump filter behind the bottom-front panel.
- UE: Rebalance the load and level the washer.
- IE: Make sure both water valves are fully open and clean the inlet hose screens.
- dE: Close the door firmly and check the latch for debris.
- Unplug the washer for 10 minutes to reset the controls.
Parts we replace most often
- Drain pump
- Door lock assembly
- Rotor position sensor
- Shock absorbers
- Inlet valve
Fix it or replace it?
LG's direct-drive motor design is durable, and most code-related repairs are single parts. Repair makes sense on nearly any LG washer under 10–12 years old. A failed main control board or tub bearing on an older unit is when we'd compare costs.
From John's notes: An LE code after a heavy load is often just an overload. Before booking, try a smaller load. If LE returns on light loads too, the rotor position sensor is the usual suspect.
LG washer throwing codes? Book an LG washer repair with TrueFix Appliance Repair Dallas.